![]() If the gap between two edges/curves is less than this value, the chain selection will ignore the gap and will select the next segment. Selects curves in both the positive and negative curve direction. Selects curves in the negative curve direction. Selects curves in the positive curve direction. Type "edge" before selecting the first segment, or uncheck the "Curves" selection filter before starting the command to only chain-select surface edges.Ĭontrols the level of continuity required between segments to be selected. Inside a command that accepts chain selection, type chain. Objects that visually seem as though they should be included, but are actually partially outside the boundary, are still included. The testing is done using a bitmap selection mask, which effectively adds an average of half a pixel wide fuzz zone around the selection boundary. NoĪ selection mask bitmap is built from the boundary, and the objects are tested against that mask. If any part of the object is even slightly outside the selection boundary, it will not be included. The testing is done in double-precision floating point in screen space. The selection wire boundary is used as the boundary. Selects objects outside and crossed by selection object or brush stroke. Selects objects completely outside the selection object or brush stroke. Selects objects crossed by the selection object or brush stroke. Selects objects completely covered by the selection object or brush stroke. Your browser does not support the video tag. Options may not appear at the command prompt.The command cannot determine which objects are to be used and the pre-selected objects are unselected, and you are prompted to select specific objects again.The command may proceed, but the result may be unexpected.The command determines that the objects can be used and proceeds without further prompting. ![]() When objects are pre-selected the possibilities include: Command prompts or options may be slightly different in the two methods. for polysurface, mesh and SubD vertices, vertexįor commands that require object input, the objects can be selected before or after the command starts.Sub-object parts can be selected and de-selected using capture tools: SelWindow and SelCrossing, Lasso, SelBrush, SelCircular, SelBoundary, SelVolumeSphere, and SelBox. To select a sub-part of an object as input to a command, type ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |